john
New Member
Posts: 1
|
Post by john on Dec 15, 2017 12:48:49 GMT -5
I have a 335 that appears to far exceed the 2.5 v range for the DT670. Using an Agilent 34410A DMM, I read 14 v across Input 1 leads. How can it exceed the 2.5 v limit?
thx
|
|
|
Post by Lake Shore Ogi on Dec 15, 2017 13:12:52 GMT -5
Dear John,
This may require a little more troubleshooting than a few messages back and forth over this forum thread. Can you please send me an email to service@lakeshore.com with the following details: 1. Details on how you performed the measurement (was a diode or anything connected to the 335 or did you connect your DMM directly to the input) 2. What pin #s you were probing 3. Details on your input configuration/settings 4. If you try the same test on the other input, do you see the same results?
Thank you, Ogi K.
|
|